European Silicon Steel Processor: We No Longer Change Blades Every Week
Writer： admin Time：2026-03-27 11:32:31
A leading European electrical steel processor—handling over 100,000 tons of grain-oriented and non-grain-oriented silicon steel annually—serves top-tier motor and transformer manufacturers worldwide.
Their original alloy steel slitting blades lasted only 7–10 days. Burrs frequently exceeded the critical 0.02mm limit. Unscheduled downtime occurred 2–3 times per month, costing over 200 hours of lost production annually. The line was in a constant state of “anxious operation.”
Then they found us. No changes to the production line. No modifications to the process. They did just one thing: changed the blades.
They switched to our YG20 tungsten carbide slitting blades, designed to fit mainstream machine models. On the surface, they look like ordinary blades. But the real difference lies where it matters most:
Change frequency dropped from 3 times per month to once every 6 months
Downtime went from 2–3 times per month to once per semester
Over 300 additional production hours gained annually
Burrs stayed below 0.02mm throughout the entire run—zero-defect audits passed with ease
Tooling cost per ton reduced by 42%
Total annual savings exceeded €120,000
Blades were no longer a source of anxiety. They became a guarantee of quality to their customers.
What the Customer Says
“We used to worry about burrs every single day. Now we change blades once every six months, and the cut quality stays perfect from start to finish. Slitting blades are no longer consumables—they are our promise to the customer.”
— Production Director, European Electrical Steel Processor
Compatible with Your Line?
We offer standard sizes with existing tooling:
D625 × d585.2 × 25mm
D635 × d595.2 × 25mm
D595.15 × d554 × 25mm
D585.15 × d544 × 25mm
Custom sizes, life cycle projections, and on-site technical support are also available. Contact us for a consultation or to request a sample test.
